[MCTG] Fwd: [MCN-Announce]- CNC

[omni at mcn.org]

-------- Original Message --------
Subject: [MCN-Announce]- CNC
Date: Sat, 20 Apr 2019 18:12:43 -0700
From: keithb at mcn.org
To: announce at lists.mcn.org

I built a CNC which has a bed of about 40"x60". It has a new 2hp router
but you could replace that with a plasma cutter if you wished. The
computer, (older model) with the Mach III software is included with the
manual. This is a project that is just about complete, it just needs the
final handshake between the computer and robotics. I spent about $2,000
and I don't have the time to complete it and I no longer have a need for
it. I really need the room so it needs to go and that's why I'm only
asking $700. I will get photos up on Craig's list next week.


__________________________________________________________
__________________________________________________________

Announcement mailing list
announce at lists.mcn.org
The Mendocino Community Network (MCN) provides the MCN Announcement list.
Use of the list is subject to the terms of service at
http://www.mcn.org/email/atos.html

__________________________________________________________
__________________________________________________________

TO POST to this list send emails to announce at lists.mcn.org 
TO UNSUBSCRIBE from this list send an email to 
announce-leave at lists.mcn.org
*** To complete the process you must reply to the email you receive in
response. ***

For listserv technical problems please contact:
listmanager at mcn.org